[Bug 91] New: VIA Rhine not enabled as eth0 (DHCP) on boot
bugzilla-daemon <[email protected]>
| Newsgroups | gmane.linux.arklinux.bugs |
|---|---|
| Message-ID | <[email protected]> |
https://bugzilla.arklinux.org/bugzilla/show_bug.cgi?id=91
Summary: VIA Rhine not enabled as eth0 (DHCP) on boot
Product: Ark Linux
Version: 1.0 alpha6
Platform: i586 (PC, Intel)
OS/Version: All
Status: NEW
Severity: Normal
Affects: Overall Usability
Component: net-tools
AssignedTo: [email protected]
ReportedBy: [email protected]
QAContact: [email protected]
Description of Problem:
Upon installation (VIA EPIA V 800 mainboard) the onboard VIA-Rhine NIC gets
detected, but it is not automatically brought up on boot. If I run the control
panel app and set it to DHCP (which should be set by default, or offered as a
choice during install), then manually run "ifup eth0" it works, and runs fine
upon a reboot. Except it kernel panics when the system is shutting down.
Version-Release number of selected component (if applicable):
ArkLinux 1.0 Alpha 6
How Reproducible:
Every time
Steps to Reproduce:
1. Install
2. No Ethernet interface
3. No DHCP by default
Actual Results:
eth0 is not up and using DHCP
Expected Results:
eth0 should be up and using DHCP
Additional Information:
Kernel panic on system shutdown once the NIC is running
------- You are receiving this mail because: -------
You are the assignee for the bug, or are watching the assignee.
You are the QA contact for the bug, or are watching the QA contact.