Re: Installing new Linux
Justin Piszcz <[email protected]>
| Newsgroups | gmane.linux.ataraid |
|---|---|
| Message-ID | <[email protected]> |
Also, I've been messing about with Linux Software RAID, but LILO won't boot my system (as root is /dev/md0). I have done this, the trick is: # Allow booting from raid1. raid-extra-boot="/dev/sda,/dev/sdb" # Also.. boot=/dev/md1 root=/dev/md2 Then when you run LILO: # lilo Added 2.6.17-2 Added 2.6.17-3 Added 2.6.17-4 Added 2.6.17-5 Added 2.6.17-6 * The boot record of /dev/md1 has been updated. The boot record of /dev/sda has been updated. The boot record of /dev/sdb has been updated. On Fri, 23 Jun 2006, Rory Vieira wrote: > Hi, > > System Info: > Asus A8N-VM CSM > AMD Athlon 64 X2 3800+ > 2 * Kingston 1Gb PC3200 ECC > 3 * Seagate 320Gb SATA-2 > Adaptec 2904 PCI + HP SureStore DAT24 > > Issue: > I would like to install SuSE 10.1 on the NVRAID environment with RAID-5. > However, during setup I get the message that my disks are part of software raid etc. > > Question: > How do I go about and install Linux? > Obviously I need a running system to actually use dmraid, so I'm unsure where to go from here. > There's no OS on the system at this point. > Also, I've been messing about with Linux Software RAID, but LILO won't boot my system (as root is /dev/md0). > I'm currently using the BootDVD to boot my system (ouch)... > > Hope someone can give me some guidelines to continue :) > > Cheers, > Rory > > > > _______________________________________________ > Ataraid-list mailing list > [email protected] > https://www.redhat.com/mailman/listinfo/ataraid-list >