[LAD] Re: Pipewire

On Wed, Aug 14, 2024 at 08:28:06PM -0400, Marc Lavallée wrote:
> 
> I tried and it works, but I had to upgrade Pipewire to a recent version;

I tried this:

- Copied pipewire.conf to ~/.config/pipewire
- Removed the jack-dbusdetect module from context.modules
- Added the jack-tunnel module to context.modules with 2 channels 
  in each direction.

Jack is running with the dbus interface disabled.
Rationale: I don't want any apps to control Jack, and dbus
is not needed to become a Jack client.

- Start pipewire
- Jack Source and Jack Sink nodes are shown in the coppwr
  'graph' window, with state = Running.
  
But no pipewire ports are shown in the Qjackctl connections
window. The 'Info' tabs in coppwr say Input Ports = 0 and
Output Ports = 0, even if the modules or configured for 2
channels each. 

No idea what to do next.

-- 
FA

_______________________________________________
Linux-audio-dev mailing list -- linux-audio-dev-cunTk1MwBs/[email protected]
To unsubscribe send an email to linux-audio-dev-leave-cunTk1MwBs/[email protected]