Re: (no subject)

On Fri, 26 Oct 2007, Tom "spot" Callaway wrote:

> 
> On Fri, 2007-10-26 at 05:09 -0400, Dean Anderson wrote:
> > Hmm. Upgrade on an Ultra10 from generic install of 2.98 to Corona 
> > results in:
> > 
> > SProgram terminated
> > 
> > And returns to boot prompt.
> > 
> > I'm trying an install from scratch. I'll let you know what happened.
> 
> This probably happened because silo was not rerun after it was upgraded.
> I'm assuming that you did a yum update, and not an anaconda upgrade?

Anaconda.  Is this known not to work?

> In the event that someone hits this again, the workaround is to boot
> into rescue mode, go into the chroot, and run /sbin/silo. Then, the
> machine should boot again.

Doh. <smack>  I should have thought of that.

-- 
Av8 Internet   Prepared to pay a premium for better service?
www.av8.net         faster, more reliable, better service
617 344 9000   


_______________________________________________
Aurora-sparc-devel mailing list
[email protected]
http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-devel
Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html