Problems in booting Aurora after installation
"GRP Productions" <[email protected]>
| Newsgroups | gmane.linux.aurora.user |
|---|---|
| Message-ID | <[email protected]> |
Hello, I have done a fresh Aurora installation in a Sun Ultra Enterprise 2, which has 3 SCSI disks. The problem is that the system won't boot, complaining like this: "The file just loaded does not appear to be executable" After doing some research over the web as well as the lists, I see this is rather a boot loader problem. However, I am able to boot the installed system properly by doing the following in the machine's prompt: >boot disk1 What can I do to enable the boot to take place automatically from disk1? (ie. typing just 'boot' instead of specifying the hard disk as well). Thank you _________________________________________________________________ Don't just search. Find. Check out the new MSN Search! http://search.msn.click-url.com/go/onm00200636ave/direct/01/ _______________________________________________ Aurora-sparc-user mailing list [email protected] http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html