Re: Problems in booting Aurora after installation

Jima <[email protected]> Fri, 7 Jul 2006 11:48:38 -0500 (CDT)

Newsgroups	gmane.linux.aurora.user
Message-ID	<[email protected]>

On Fri, 7 Jul 2006, GRP Productions wrote:
> What can I do to enable the boot to take place automatically from disk1? (ie. 
> typing just 'boot' instead of specifying the hard disk as well).

  IIRC, by modifying the 'boot-device' variable:

ok printenv boot-device
boot-device =         disk:a disk disk1 net
ok setenv boot-device disk1 disk:a disk net
boot-device =         disk1 disk:a disk net
ok

  Re-ordering the boot order so disk1 is first should do the job.  Let us 
know if it doesn't.

      Jima
_______________________________________________
Aurora-sparc-user mailing list
[email protected]
http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user
Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html