Re: Aurora 2.0 install failure on Sun Ultra 10

Hi,

I've had exactly the same problem with an ultra5 and
an ultra30. It is probably caused by CDs burned at a
speed higher than 4.

HOwever, even with 4x-burned CDs, the problem may
appear again. Usually, the machine is convinced to
read the CD at the 4th or 5th attempt...

Something else that may be also relevant: I noticed
that ultra5s and I suppose also ultra10s, don't like
CDROMS reading at speeds greater than 32x. I installed
a 52x on an ultra5, and I had very often problems
reading CDs. The problem disappeared when I put back
the original 32x CDROM.

Joseph


--- Drokare <[email protected]> wrote:

> Sorry for my lack of information earlier... I feel
> like an idiot I
> should have know to put more information.
> 
>  
> 
> Anyways I have an Sun Ultra 10 System that I am
> trying to install Aurora
> 2.0 and it is failing during the install.
> 
>  
> 
> I have used the "stop a" ran the boot cdrom but I
> get the following
> error as it tries to load the Linux.
> 
>  
> 
> Boot:
> 
> Allocated 8 Megs of memory at 0x40000000 for kernel
> 
> Loaded Kernel version 2.6.13
> 
> Loading initial ramdisk (2522576 bytes at 0x1FC02000
> phys, ox40C00000
> virt) ...
> 
> Illegal Instruction
> 
> Ok
> 
>  
> 
> That is all I get?  Any ideas?  Thanks in advanced.
> 
>  
> 
> -Drokare
> 
> > _______________________________________________
> Aurora-sparc-user mailing list
> [email protected]
>
http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user
> Aurora FAQ:
http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
Aurora-sparc-user mailing list
[email protected]
http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user
Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html