Re: install problems on a blade2000
"Tom \"spot\" Callaway" <[email protected]>
| Newsgroups | gmane.linux.aurora.user |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 2007-04-12 at 17:46 +1200, Annie Lindale & Alexander Lange wrote: > Hello all > I have down- loaded the iso images for aurora 2.98 and burned them to > disc. So far so good. The install will go further than with aurora 2 > but when the installer installs the synbios SCSI driver the system comes > to a halt, crashes and burns. I cannot even use stop + a to get back to > the open boot. > Any ideas? > Thanks > Alexander OK, if you're doing an install with a monitor and keyboard attached, please change to the other VTs (ctrl-alt-f2, f3, f4, f5) and look for any error messages. Please send those along. Thanks, ~spot _______________________________________________ Aurora-sparc-user mailing list [email protected] http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html