Re: Aurora 2.0 new install on Ultra1
mat <[email protected]>
| Newsgroups | gmane.linux.aurora.user |
|---|---|
| Message-ID | <[email protected]> |
Bruce Ferrell wrote: > I just installed Aurora 2.0 to my Ultra 1 with 256M with only a false > start for badly burned CD. Burned at 4x and that went away. > > The system is hanging in the interactive boot initializing swap. does > it very consistantly. It's also incredably slow. Much slower than it > was with Aurora 1.0 > > Any suggestions? My ultra1 was rock solid under 2.0 for well over a year - you're not using X, are you? X is going to be very slow on a 167mhz cpu no matter how you look at it. Anything in the logs? Does it always hang? I guess not, if you know that it runs slow you must have booted it successfully at least once. Did you choose the standard partitioning or manually create something a bit non-standard? Personally, I'd disable swap in /etc/fstab and manually set it up with swapon once booted to do a bit more poking around. Might be worth running the full diagnostics from the OBP as well while you're at it. Good luck. -- [email protected] | www.fsck.no-ip.org _______________________________________________ Aurora-sparc-user mailing list [email protected] http://lists.auroralinux.org/mailman/listinfo/aurora-sparc-user Aurora FAQ: http://www.ecs.soton.ac.uk/~mas01r/aurorafaq.html