Re: Anycom USB-250 unseen by hcitool

On 05/15/2008 04:41 AM, Marcel Holtmann wrote:
> Hi Mumia,
> 
>> Hello. I recently bought an Anycom USB-250 Bluetooth 
>> adapter, and I'm trying to get it to work with my Palm 
>> Tungsten E2 so that I can get online on the E2.
>>
>> However, I can't get it to work. When I run "hcitool scan", 
>> I get this error message: "Device is not available: No such 
>> device."
> 
> check with hciconfig -a and make sure that either the hci_usb or btusb 
> driver is loaded.
> 
> Regards
> 
> Marcel
> 

Thanks Marcel; "hciconfig -a" returns nothing:

$ hciconfig -a
$

After I manually load hci_usb, "hciconfig -a" returns this:

$ hciconfig -a
hci0:   Type: USB
         BD Address: 00:00:00:00:00:00 ACL MTU: 0:0 SCO MTU: 0:0
         DOWN
         RX bytes:0 acl:0 sco:0 events:0 errors:0
         TX bytes:0 acl:0 sco:0 commands:0 errors:0

However, I don't have the btusb module, and I can't see any way to build 
it from "make menuconfig." When I configured my kernel before, I enabled 
/everything/ related to bluetooth. :-?

Hmm, "hcitool" still doesn't see my bluetooth dongle:

$ hcitool scan
Device is not available: No such device

:-?



-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft 
Defy all challenges. Microsoft(R) Visual Studio 2008. 
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/