Re: Anycom USB-250 unseen by hcitool

Hi Mumia,

> >> Hello. I recently bought an Anycom USB-250 Bluetooth 
> >> adapter, and I'm trying to get it to work with my Palm 
> >> Tungsten E2 so that I can get online on the E2.
> >>
> >> However, I can't get it to work. When I run "hcitool scan", 
> >> I get this error message: "Device is not available: No such 
> >> device."
> > 
> > check with hciconfig -a and make sure that either the hci_usb or btusb 
> > driver is loaded.
> > 
> > Regards
> > 
> > Marcel
> > 
> 
> Thanks Marcel; "hciconfig -a" returns nothing:
> 
> $ hciconfig -a
> $
> 
> After I manually load hci_usb, "hciconfig -a" returns this:
> 
> $ hciconfig -a
> hci0:   Type: USB
>          BD Address: 00:00:00:00:00:00 ACL MTU: 0:0 SCO MTU: 0:0
>          DOWN
>          RX bytes:0 acl:0 sco:0 events:0 errors:0
>          TX bytes:0 acl:0 sco:0 commands:0 errors:0
> 
> However, I don't have the btusb module, and I can't see any way to build 
> it from "make menuconfig." When I configured my kernel before, I enabled 
> /everything/ related to bluetooth. :-?
> 
> Hmm, "hcitool" still doesn't see my bluetooth dongle:

hciconfig hci0 up :)

Regards

Marcel



-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft 
Defy all challenges. Microsoft(R) Visual Studio 2008. 
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/