using bluez without the dbus-daemon, just dbus-lib as peer-to-peer connection

Hi,

dbus can be used in two modes, on the one hand just the dbus library in
order to establish a point-to-point communication between two processes,
on the other hand with the dbus-daemon which uses the library in order to
allow the communication of many different processes with each other.

In my specific scenario I have to safe system resources since I'm developing
for an embedded arm system and I only have one single application which has
to communicate with bluez.

Is it possible to use bluez only with the dbuslib (without dbus-daemon) in
order to establish a point-to-point communication between bluez and an
application which uses the bluez/bluetooth features?
If yes which part of bluez is responsible for doing that?
Are there any differences in the view of bluez-functionalities between this
two modes of communication besides the obvious that there can be only one
peer-to-peer connection?

thanks a lot.

-- 
Regards,
--Codefritz

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft 
Defy all challenges. Microsoft(R) Visual Studio 2008. 
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Bluez-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users