Re: drbd ha-lvs dr problems

Karsten Nielsen wrote:
> I have setup opessi 1.9.3 from john's debian etch packages. And I have setup 
> drbd failover on the to initnodes.
>
> I am planing on running a mailscanner cluster on the setup but I have run into 
> an issue with the setup and that.
>
> I have setup ha-lvs to serve the cluster and started the services on all the 
> nodes. The setup works perfectly until I make a hard fail of the running 
> master. The master sits in the ip pool and does not get removed. My cvip.conf 
> is below.
> Any suggestions ?
>   
I've not done much (any!) testing of ha-lvs yet.  I'll see what I can find.
> I have another problem and that is if I cut the power on initnode 1 initnode 2 
> takes over and the cluster continues as planned. But when i start initnode 1 
> again i sits waiting to take over the master settings from initnode 2 during 
> boot and just waiting and waiting. Is there any thing I have to do in order 
> for it to become master again ?
>   
Normaly it won't become the master, it'll join as a secondary.

When you say it's waiting and waiting what are the last messages displayed.

I haven't tried drbd yet, my tests have all been with shared disk.


-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/