Re: drbd ha-lvs dr problems

On Monday 21 July 2008 15:09:20 you wrote:
> Karsten Nielsen wrote:
> > I have setup opessi 1.9.3 from john's debian etch packages. And I have
> > setup drbd failover on the to initnodes.
> >
> > I am planing on running a mailscanner cluster on the setup but I have run
> > into an issue with the setup and that.
> >
> > I have setup ha-lvs to serve the cluster and started the services on all
> > the nodes. The setup works perfectly until I make a hard fail of the
> > running master. The master sits in the ip pool and does not get removed.
> > My cvip.conf is below.
> > Any suggestions ?
>
> I've not done much (any!) testing of ha-lvs yet.  I'll see what I can find.

Thanks that sounds great. 

>
> > I have another problem and that is if I cut the power on initnode 1
> > initnode 2 takes over and the cluster continues as planned. But when i
> > start initnode 1 again i sits waiting to take over the master settings
> > from initnode 2 during boot and just waiting and waiting. Is there any
> > thing I have to do in order for it to become master again ?
>
> Normaly it won't become the master, it'll join as a secondary.

ok I did not know that :)

>
> When you say it's waiting and waiting what are the last messages displayed.

I cannot recreate that at the moment because the cluster broke as in it cannot 
start any more. So I have to start over with a clean install.

>
> I haven't tried drbd yet, my tests have all been with shared disk.

-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/