On 1/15/2021 1:07 AM, Thomas Lange wrote:
>>>>>> On Thu, 14 Jan 2021 12:19:30 -0800, [email protected] said:
>
> > I am attempting to build Debian "bullseye/sid" (pre-release bullseye)
> > using FAI 5.9.4. The network interface names come out being inconsistet,
> Maybe you are missing this patch which is not in 5.9.4 included:
>
> https://github.com/faiproject/fai-config/commit/45a802ca5f0a7cc229edb4cedd1b22ab4f790ba4
>
I think I am narrowing down where the issue might be. I am seeing a
difference when booting between a buster and a bullseye NFS ROOT.
I do the initial FAI imaging using a buster NFS root and install buster
in /target. When I then run "chroot /target udevadm info
/sys/class/net/eth0" I see about 27 lines including a bunch of
ID_NET_NAME_* values.
I do the above again, but this time with a bullseye NFS root and install
bullseye in /target. When I then run "chroot /target udevadm info
/sys/class/net/eth0" I see only about 6 lines and, in particular, no
ID_NET_NAME_* values.
I created the bullseye NFS root in the same way as for buster (I think).
Why is there this large difference in the outputs of udevadm info?
Note that I used FAI 5.9.4 to create the NFS root for bullseye.
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.