Re: FAI with pre-release bullseye yielding inconsistent network names
Stefan Möding <[email protected]>
| Newsgroups | gmane.linux.debian.fai |
|---|---|
| Message-ID | <[email protected]> |
[email protected] writes: > I do the initial FAI imaging using a buster NFS root and install buster in > /target. When I then run "chroot /target udevadm info /sys/class/net/eth0" > I see about 27 lines including a bunch of ID_NET_NAME_* values. > I do the above again, but this time with a bullseye NFS root and install > bullseye in /target. When I then run "chroot /target udevadm info > /sys/class/net/eth0" I see only about 6 lines and, in particular, no > ID_NET_NAME_* values. This is the reason why the script does not pick up the correct name. > I created the bullseye NFS root in the same way as for buster (I think). Why > is there this large difference in the outputs of udevadm info? Does the following show more output on Bullseye? # chroot /target udevadm info --query=all /sys/class/net/eth0 -- Stefan