Re: Dracut : Could not boot
bruno pinto <[email protected]>
| Newsgroups | gmane.linux.debian.fai |
|---|---|
| Message-ID | <[email protected]> |
Hello Thomas, How you put in the initrd the new firmwar? Thanks a lot, --------------------------------------- Bruno FERREIRA PINTO Service Informatique IJCLab IN2P3/CNRS Universite Paris-Sud 11 Rue André Ampere Bt 100A Pce A118 91898 Orsay Cédex --------------------------------------- ----- Mail original ----- De: "Thomas Lange" <[email protected]> À: "fully automatic installation for Linux" <[email protected]> Envoyé: Mercredi 13 Juillet 2022 09:20:39 Objet: Re: Dracut : Could not boot >>>>> On Tue, 12 Jul 2022 13:47:29 +0200 (CEST), bruno pinto <[email protected]> said: > I have inside the NFSROOT : firmware-linux-nonfree > I know what firmware I need: https://fwupd.org/lvfs/devices/com.dell.uefi398c4c37.firmware Using this command you can see which files are included in the initrd that FAI is using: /srv/fai/nfsroot/usr/bin/lsinitrd /srv/fai/nfsroot/boot/initrd.img* | less -- regards Thomas