Re: Any success with real hardware?

João Pedro Malhado <[email protected]>
Newsgroups gmane.linux.debian.ports.hurd
Message-ID <aJPIALOi--ymOZ4K@anne-frank>
Hello Dennis,

On Tue, Aug 05, 2025 at 06:30:40PM -0400, Dennis Clarke wrote:
>     Neither a SATA SSD nor an old old Seagate 512Kb byte sector disk
> would work. I see GRUB just fine and then some boot messages begin and
> then bad stuff regarding a disk. Will the current img file only work on
> very specific Intel hardware from a given era?

I have run Debian hurd-i386 on different laptop models none of which
particularly recent. I have found that I usually need to set the disk settings
on the BIOS to compatibility mode, and I have always found issues when trying
AHCI mode (both with rumpdisk and in-kernel drivers)

Are you trying to use rumpdisk? For that you would need to add the noide flag on
your gnumach line on your GRUB configuration. 
https://darnassus.sceen.net/~hurd-web/hurd/rump/rumpdisk/

Rather than using the pre-installed images, you may try the installer and see if
your disk is detected there.

I hope that helps somehow.
Regards,
João
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.