Re: Diske ikke brugbare efter skift af styredisk

Kim Petersen wrote:

> Hej. Jeg har et problem som jeg håber at i kan hjælpe mig med.
> Jeg har en server, Debian GNU/Linux 3.1 som jeg kun har ssh-adgang til.
> På den maskine har jeg 4 diske siddende på et promise kort.
> Efter at maskinen har fået en ny styre disk, kan jeg ikke
> længere få adgang til disse 4 diske, styredisken og et 5 drev er
> der ingen problemer med at se.
> ---- uddrag af dmesg følger:
> Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
> ide: Assuming 33MHz system bus speed for PIO modes; override with 
> idebus=xx
> PIIX4: IDE controller at PCI slot 0000:00:04.1
> PIIX4: chipset revision 1
> PIIX4: not 100% native mode: will probe irqs later
>    ide0: BM-DMA at 0xd800-0xd807, BIOS settings: hda:DMA, hdb:DMA
>    ide1: BM-DMA at 0xd808-0xd80f, BIOS settings: hdc:pio, hdd:pio
> PDC20268: IDE controller at PCI slot 0000:00:0b.0
> PCI: Found IRQ 10 for device 0000:00:0b.0
> PDC20268: chipset revision 2
> PDC20268: 100% native mode on irq 10
>    ide2: BM-DMA at 0xa400-0xa407, BIOS settings: hde:pio, hdf:pio
>    ide3: BM-DMA at 0xa408-0xa40f, BIOS settings: hdg:pio, hdh:pio
> PDC20262: IDE controller at PCI slot 0000:00:0d.0
> PCI: Found IRQ 5 for device 0000:00:0d.0
> PCI: Sharing IRQ 5 with 0000:00:04.2
> PDC20262: chipset revision 1
> PDC20262: 100% native mode on irq 5
> PDC20262: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode.
>    ide4: BM-DMA at 0x8800-0x8807, BIOS settings: hdi:DMA, hdj:pio
>    ide5: BM-DMA at 0x8808-0x880f, BIOS settings: hdk:pio, hdl:pio
> hda: IC35L180AVV207-1, ATA DISK drive
> hdb: ASUS CD-S400/A, ATAPI CD/DVD-ROM drive
> hdg: Maxtor 4G120J6, ATA DISK drive
> hdi: probing with STATUS(0x50) instead of ALTSTATUS(0x00)
> hdi: WDC WD1200JB-75CRA0, ATA DISK drive
> hdj: probing with STATUS(0x50) instead of ALTSTATUS(0x00)
> hdj: WDC WD1200JB-75CRA0, ATA DISK drive
> hdk: WDC WD1200JB-75CRA0, ATA DISK drive
> hdl: Maxtor 4G120J6, ATA DISK drive
> Using anticipatory io scheduler
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide3 at 0xb000-0xb007,0xa802 on irq 10
> ide4 at 0xa000-0xa007,0x9802 on irq 5
> ide5 at 0x9400-0x9407,0x9002 on irq 5
> hda: max request size: 1024KiB
> hda: 361882080 sectors (185283 MB) w/7965KiB Cache, CHS=22526/255/63, 
> UDMA(33)
> /dev/ide/host0/bus0/target0/lun0: p1 p2 < p5 p6 >
> hdg: max request size: 1024KiB
> hdg: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=16383/255/63, 
> UDMA(100)
> /dev/ide/host2/bus1/target0/lun0: p1
> hdi: max request size: 128KiB
> hdi: Host Protected Area detected.
>        current capacity is 234375000 sectors (120000 MB)
>        native  capacity is 234441648 sectors (120034 MB)
> hdi: 234375000 sectors (120000 MB) w/8192KiB Cache, CHS=65535/16/63, 
> UDMA(66)
> /dev/ide/host4/bus0/target0/lun0: p1 p2
> hdj: max request size: 128KiB
> hdj: Host Protected Area detected.
>        current capacity is 234375000 sectors (120000 MB)
>        native  capacity is 234441648 sectors (120034 MB)
> hdj: 234375000 sectors (120000 MB) w/8192KiB Cache, CHS=65535/16/63, 
> UDMA(66)
> /dev/ide/host4/bus0/target1/lun0: p1 p2
> hdk: max request size: 128KiB
> hdk: Host Protected Area detected.
>        current capacity is 234375000 sectors (120000 MB)
>        native  capacity is 234441648 sectors (120034 MB)
> hdk: 234375000 sectors (120000 MB) w/8192KiB Cache, CHS=65535/16/63, 
> UDMA(66)
> /dev/ide/host4/bus1/target0/lun0: p1
> hdl: max request size: 1024KiB
> hdl: 240121728 sectors (122942 MB) w/2048KiB Cache, CHS=16383/255/63, 
> UDMA(66)
> /dev/ide/host4/bus1/target1/lun0: p1
> ----- uddrag slut:
> Diskene det drejer sig om er i,j,k og l
> fdisk kan heller ikke åbne dem.
> Hvad gør jeg, for at få fat i dem igen ? Helst uden data-tab.

Jeg gætter på at du bare mangler device filerne.

Prøv

cd /dev; MAKEDEV hdi hdj hdk hdl

Er de del af et sw raid?

Peter

-- 
#! Peter Loje Hansen
#! http://hashbang.org


-- 
To UNSUBSCRIBE, email to [email protected]
with a subject of "unsubscribe". Trouble? Contact [email protected]