Now no access point found (Re: Suse 9 hangs after SMC2662W V3 hotplug)

"Andreas Schroff" <[email protected]>
Newsgroups gmane.linux.drivers.at76c503a.user
Message-ID <000d01c3ce24$fa2b92d0$8d7ba8c0@Cybercom>
Hello,
in the mean time, I followed a hint in a similar posting. I did:

rmmod usb-uhci
insmod uhci

Now the systems hangs not anymore and delivers output for the iwconfig
command. After setting the configuration I receive:

IEEE 802.11-DS  ESSID:"default"
Mode:Managed  Channel:6  Access Point: 00:00:00:00:00:00
Bit Rate:11Mb/s
RTS thr:off   Fragment thr:off
Encryption key:XXXX-XXXX-XXXX-XXXX-XXXX-XXXX-XX   Security mode:open
Power Management:off
Link Quality:0  Signal level:0  Noise level:0
Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
Tx excessive retries:0  Invalid misc:0   Missed beacon:0



Using these options I use in windows xp, I cannot find my access point. If I
restart my machine with windows, I also need to unplug my SMC2662 device,
before it works again.



Is this related to firmware version somehow? The log tells me, that it uses
the compiled-in firmware. Firmware version ist displayed as 8.101.5 #84.



Thank you



Andreas



> Hello,
>
> I use Suse 9 (Kernel 2.4.21) and have installed the at76c503a. After I
plug
> my SMC2662 V3 adapter in, my systems hangs. After a reboot I can find the
> following log:
>
> Dec 28 22:19:11 linux kernel: at76c503.c: Generic Atmel at76c503/at76c505
> routines v0.12beta2
> Dec 28 22:19:11 linux kernel: at76c503-fw_skel.c: Atmel at76c503
> (RFMD/Accton) Wireless LAN Driver v0.12beta2 loading
> Dec 28 22:19:11 linux kernel: usb.c: registered new driver
at76c503-rfmd-acc
> Dec 28 22:20:13 linux kernel: at76c503-fw_skel.c: using compiled-in
firmware
> Dec 28 22:20:13 linux kernel: at76c503.c: getting firmware failed with 0,
or
> version is 0
> Dec 28 22:20:13 linux kernel: at76c503.c: this probably means that the
ext.
> fw was not loaded correctly
>
>
>
> I read some postings about driver problems with usb code in some kernel
> versions. As a Linux-Wlan-newbie, the reason for my problem should be much
> simpler....
>
>
>
> Thank you
>
>
> Andreas
>
> _______________________________________________
> at76c503a-user mailing list
> [email protected]
> http://lists.berlios.de/mailman/listinfo/at76c503a-user
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.