Re: linksys WUSB11 v2.6 working

Why not just set the interface to up? 


On Sun, 2004-01-11 at 18:03, Alex Schultz wrote:
> Stephen G Smith wrote:
> 
> > just wanted to mention that i have gotten my wusb11 2.6 working with 
> > the <http://at76c503a.berlios.de/> at76c503a driver and the 1.101.0-84 
> > firmware. i'm using the latest CVS tarball without the Dossy patch, 
> > running on Mandrake 9.2. one interesting thing though. after i do 
> > "iwconfig wlan0 essid <my-essid> mode managed etc...", the adapter 
> > does not report a link and iwconfig reports the AP as 
> > 00:00:00:00:00:00 until i manually assign an IP to wlan0. then 
> > everything works fine. anybody know why this is?
> >
> > also, what is the outlook on supporting promiscuous/monitor mode in 
> > the future?
> >
> > thanks...
> >
> > Stephen Smith
> >
> > _______________________________________________
> > at76c503a-user mailing list
> > [email protected]
> > http://lists.berlios.de/mailman/listinfo/at76c503a-user
> >
> I had the same problem at first. You have to set the IP before the 
> card's radio turns on. I believe that that is intended behavior for the 
> driver.
> 
>              Al
> 
> _______________________________________________
> at76c503a-user mailing list
> [email protected]
> http://lists.berlios.de/mailman/listinfo/at76c503a-user