Re: linksys WUSB11 v2.6 working
Alex Schultz <[email protected]>
| Newsgroups | gmane.linux.drivers.at76c503a.user |
|---|---|
| Message-ID | <[email protected]> |
That should work, but I never had a need to, I use a static IP for it
anyways. Just for everyone who's reading this, you can set the interface
to up with "ifconfig wlan0 up" where wlan0 is the network card.
Al
Chris Fowler wrote:
>Why not just set the interface to up?
>
>
>On Sun, 2004-01-11 at 18:03, Alex Schultz wrote:
>
>
>>Stephen G Smith wrote:
>>
>>
>>
>>>just wanted to mention that i have gotten my wusb11 2.6 working with
>>>the <http://at76c503a.berlios.de/> at76c503a driver and the 1.101.0-84
>>>firmware. i'm using the latest CVS tarball without the Dossy patch,
>>>running on Mandrake 9.2. one interesting thing though. after i do
>>>"iwconfig wlan0 essid <my-essid> mode managed etc...", the adapter
>>>does not report a link and iwconfig reports the AP as
>>>00:00:00:00:00:00 until i manually assign an IP to wlan0. then
>>>everything works fine. anybody know why this is?
>>>
>>>also, what is the outlook on supporting promiscuous/monitor mode in
>>>the future?
>>>
>>>thanks...
>>>
>>>Stephen Smith
>>>
>>>_______________________________________________
>>>at76c503a-user mailing list
>>>[email protected]
>>>http://lists.berlios.de/mailman/listinfo/at76c503a-user
>>>
>>>
>>>
>>I had the same problem at first. You have to set the IP before the
>>card's radio turns on. I believe that that is intended behavior for the
>>driver.
>>
>> Al
>>
>>_______________________________________________
>>at76c503a-user mailing list
>>[email protected]
>>http://lists.berlios.de/mailman/listinfo/at76c503a-user
>>
>>
>
>_______________________________________________
>at76c503a-user mailing list
>[email protected]
>http://lists.berlios.de/mailman/listinfo/at76c503a-user
>
>
>