Re: Hotplug works, Reboot works, Cold Start - no work

	I hope that remedies your problem.  It sure sounds like a bizarre
conflict.


You wrote:

> On Tuesday 13 January 2004 6:54 am, David Haggett wrote:
> 
> > > VIA chipset.  I see you are using uhci.  Maybe trying with
> > > usb-uhci
> >
> > I haven't tried usb-uhci  since upgrading from version 0.10, which
> > suffered frequent system lock-ups when downloading the firmware. 
> > I have (just) reconfigured so that it does.  I won't know if it
> > has worked completely until the machine has been off for a few
> > hours.
> 
> It's looking a bit better now...  I started the system yesterday
> p.m. (using the usb-uhci module), and no wlan0.  Rebooted
> immediately and wlan0 was up and configured (looked like no change
> from uhci).
> 
> This morning, however (machine off for 12hours) wlan0 was there from
> first boot!!! The difference?....  This time I had left my USB
> scanner plugged in.  It shares an on-board hub with the wireless
> adaptor.  I'd unplugged it to try to reduce the load on my power
> supply.
> 
> I'm not sure this is an actual fix yet.... one success doesn't make
> it a rule, and there is a slight logical problem with the apparent
> solution.  But if I don't post against this thread again assume it
> is.
> 
> Thanks again for the suggestions.