Re: CnetWUSB611 - (vend/prod 0x1371/0x13)

I had a lot of hassles only a couple of weeks ago getting the drivers to
work with 1371/0001. I downloaded from CVS and eventually worked out
that I needed to change the Makefile:

# altered from usb to 3rdParty
MODULE_DIR =
$(DESTDIR)/lib/modules/$(KERNEL_VERSION)/kernel/drivers/3rdParty/at76c503

Without this change you will be unable to pickup the correct driver in
Mdk 9.2.

Make sure you have disabled the other at76 driver from the
atmelwlandriver mob.
		
Email the list if you need more help. Since getting it going, I have
copied just the modules to another 9.2 machine and had it work
hunky-dory.

HTH

Stuart

On Wed, 2004-01-28 at 00:50, Derek Jennings wrote:
> I am trying to assist a newbie to get his CnetWUSB611 working with Mandrake 
> 9.2.
> 
> I saw the earlier thread on this list about Cnet611, but in this case the 
> vendor/product code is 0x1371/0x13
> 
> Using the CVS version of the driver I see the at76c505-rfmd2958 version 
> supports 0x1371/0x13, but when the device is inserted the log shows :-
> 
> usb.c: USB disconnect on device 00:1f.2-2, assigned address 2
> hub.c: new USB device 00:1f.2-2, assigned address 3
> at76c503-fw_skel.c: using compiled-in firmware
> at76c503.c: Downloading external firmware failed: -22
> usb.c: USB device 3 (vend/prod 0x1371/0x13) is not claimed by any active
> driver.
> 
> 
> I made sure the Mandrake supplied driver version had been removed to ensure it 
> did not interfere.
> 
> Is it known for sure that the at76c505-rfmd2958 driver works with this device?
> 
> Thanks
> 
> derek
> 
> _______________________________________________
> at76c503a-user mailing list
> [email protected]
> http://lists.berlios.de/mailman/listinfo/at76c503a-user
>