Re: probs with a Linksys WUSB11 ver2.8 in Mandrake...

Ryan Mueller <[email protected]>
Newsgroups gmane.linux.drivers.at76c503a.user
Message-ID <[email protected]>
Sorry about not stripping the re:'s....that was ignorant of me. :/

Anywho.....the line in the syslog is as such:

at76c503.c: device's MAC 00:0c:41:56:67:89   regulatory domain FCC (U.S) 
(id 16)
at76c503.c: registered wlan0

The debug info from the syslog:

kernel: at76c503.c: wlan0 param: ssid linksys (6C696E6B737973) mode 
infra ch 10 wep disabled key 0 keylen 0 
kernel: at76c503.c: wlan0 param: preamble long rts 1536 frag 1536 txrate 
11MBit excl 0
kernel: at76c503.c: wlan0 param: pm_mode 1 pm_period 0 auth_mode open 
scan_timer 10 120 scan_mode active
kernel: at76c503.c: wlan0: state 0 -> (SCANNING)
kernel: at76c503.c: wlan0: BSS table (curr=00000000,   new=00000000):
kernel: at76c503.c: 0xce671dc0: bssid 00:0c:41:48:03:50 channel 6 ssid 
linksys (6C696E6B737973) capa x0005
                               rates 82 84 0B 16 rssi 49 link 0 noise 0
kernel: at76c503.c: wlan0: BSS table (curr=00000000,   new=00000000):
kernel: at76c503.c: 0xce671dc0: bssid 00:0c:41:48:03:50 channel 6 ssid 
linksys (6C696E6B737973) capa x0005
                               rates 82 84 0B 16 rssi 46 link 0 noise 0
kernel: at76c503.c: wlan0: state 1 -> 6 (JOINING)
kernel: at76c503.c: wlan0: find_matching_bss: returned ce671dc0
kernel: at76c503.c: wlan0: join addr 00:0c:41:48:03:50 ssid linksys type 
2 ch 6 timeout 2000
kernel: at76c503.c: wlan0: state 6 -> 2 (AUTHENTICATING)
kernel: at76c503.c: wlan0: state 2 -> 3 (ASSOCIATING)
kernel: at76c503.c: wlan0: state 3 -> 7 (CONNECTED)
kernel: at76c503.c: wlan0: connected to BSSID
kernel: at76c503.c: wlan0: state 7 -> 0 (INIT)
network: shutting down interface wlan0: succeeded
network: shutting down loopback interface: succeeded
network: setting network parameters: succeeded
ifup: Determing IP information for wlan0......failed
ifup: no link present.......check cable
network: bringing up interface wlan0: failed

This seems odd....because it looks to me that it is connecting, but then 
shuts it down and loses it for some reason. Any thoughts?

Ryan
[email protected]
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.