at76c503 on sun ultra 10

Hello,

I have been using the berlios driver (at76c503-i3861) with RH9 and my 
linksys USB wireless card for a couple of years now on a Pentium III 
box.  Someone recently gave me an Sun Ultra 10 and I am trying to get 
the linksys card to work.  I'm running gentoo linux for sparc kernel 
version 2.4.25.  I added a USB PCI card (NECchipset uses OHCI and EHCI)  
I've compiled the driver and have enabled wireless in my kernel.  It 
appears that the driver marries itself to the card properly but when I 
try to run iwconfig I get "wlan0 no wireless extensions".

Is anyone out there using these drivers on a sun box?  For some reason 
after all my searching, I am under the impression that maybe I should 
try the 2.6 kernel.  Do you agree?  Any other advice would be 
appreciated.  Below is the output from a few commands.

Thanks,




 From my kernel config
                                                                               
 
CONFIG_NET_RADIO=y
CONFIG_NET_WIRELESS=y
                                                                               
 
--------------------------------------------------
 # iwconfig --version
iwconfig  Wireless-Tools version 27
          Compatible with Wireless Extension v11 to v16.
                                                                               
 
           Kernel    Currently compiled with Wireless Extension v16.
                                                                               
 
--------------------------------------------------
 # iwconfig
lo        no wireless extensions.
                                                                               
 
eth0      no wireless extensions.
                                                                               
 
wlan0     no wireless extensions.
                                                                               
 
--------------------------------------------------
 #  dmesg
          
hub.c: new USB device 02:03.0-3, assigned address 2
input: USB HID v10.01 Mouse [Microsoft Microsoft 3-Button Mouse with
IntelliEye(TM)] on usb2:2.0
sunmouse: Successfully adjusted to 1200 baud.
hub.c: new USB device 02:03.1-2, assigned address 2
usb.c: USB device 2 (vend/prod 0x66b/0x2211) is not claimed by any active
driver.
at76c503.c: Generic Atmel at76c503/at76c505 routines v0.11
usbdfu.c: USB Device Firmware Upgrade (DFU) handler v0.11
usb.c: registered new driver usbdfu
at76c503-i3861.c: Atmel at76c503 (Intersil 3861) Wireless LAN Driver v0.11
usb.c: registered new driver at76c503-i3861
at76c503.c: $Id: at76c503.c,v 1.35 2003/07/30 06:31:51 jal2 Exp $ 
compiled Apr
18 2004 20:17:28
at76c503.c: firmware version 0.90.0 #2 (fcs_len 4)
at76c503.c: device's MAC 00:04:5a:c8:b1:02, regulatory domain <unknown> (id
255)at76c503.c: registered wlan0
sys32_ioctl(iwconfig:2209): Unknown cmd fd(3) cmd(00008b1a) arg(effffce0)
sys32_ioctl(iwconfig:2215): Unknown cmd fd(3) cmd(00008b04) arg(effffd10)
at76c503.c: using BSSID 02:00:8a:d4:68:00
sys32_ioctl(iwconfig:2278): Unknown cmd fd(3) cmd(00008b01) arg(effff010)
sys32_ioctl(iwconfig:2278): Unknown cmd fd(3) cmd(00008b01) arg(effff010)
sys32_ioctl(iwconfig:2278): Unknown cmd fd(3) cmd(00008b01) arg(effff010)