Re: Problems with Atmel at76c503 drivers and SuSE 9.0

Hi Jörg,

Joerg Albert wrote:
[snip]
> 
> Warmbooting from WinXP usually never works without re-plugging the USB
> device, as the WinXP driver has loaded a different firmware into the
> device, which stays alive there.
Aha, good to know.

>>3.) when unlugging and re-plugging the adapter in most cases the system
>>works. In the other cases (approx. 20%) the adapter is either not
>>recognized or the system hangs again
> 
> 
>>Since I am a little bit swamped with the interpretation of the kernel
>>messages I would like to ask the experts for their advice.
> 
> 
> You need to run the complete oops message thru ksymoops to provide any
> useful information.
> 
> But I'd first start to try a newer driver version, 0.11 from
> http://at76c503a.berlios.de.
Thank you very much for that tip. This seems to work for now.
BTW: thanks a lot for the great work that you did so far with the drivers.

Regards,
Arend

> 
> If you've got an UHCI hostcontroller, try to use the other driver (uhci/usb-uhci).
> 
> Try to build another kernel without usbdevfs support.
> 
> There were some discussions in the Berlios mailing lists about SuSE 9.0,
> check the archives.
> 
> /Jörg
> 
> 
> _______________________________________________
> Atmel-wlan-usb mailing list
> Atmel-wlan-usb-ikZNBd7uB5wQUIZIPwn63sWURRETrGNnG9Ur7JDdleE@public.gmane.org
> https://iprserv.jura.uni-leipzig.de/mailman/listinfo/atmel-wlan-usb
>