Re: Repeatit RS/3 Client Terminal and Mandrake 10.1

Kjell Andersson wrote:

> Hi
>
> I've phurcased a wlan-adapter Repeatit RS/3 Client Terminal.
> (swedish manufacturer). It's on usb, and using Atmel AT76C503A. Linux=20
> reports the vendorID as 0x3eb and productID as 0x7604.
> I am using Mandrake 10.1.
> When I hooked up the modem it come up in usbview as at76c503-i3863,
> but after two seconds it is going red!
> Command iwconfig show no adapter.
> This is  the errors log:
> <snip>
> Any suggestions on what I should do appreciated.
>
> Thanks!
>
> Kjell Andersson
> Sweden


Hello Kjell,

I've got the same model, and I've posted to this list about the same=20
problem. :-)

http://iprserv.jura.uni-leipzig.de/pipermail/atmel-wlan-usb/2003-July/001=
902.html
http://iprserv.jura.uni-leipzig.de/pipermail/atmel-wlan-usb/2003-July/001=
903.html
http://iprserv.jura.uni-leipzig.de/pipermail/atmel-wlan-usb/2003-July/001=
917.html
http://iprserv.jura.uni-leipzig.de/pipermail/atmel-wlan-usb/2003-July/001=
918.html
http://iprserv.jura.uni-leipzig.de/pipermail/atmel-wlan-usb/2003-July/002=
032.html
http://iprserv.jura.uni-leipzig.de/pipermail/atmel-wlan-usb/2003-July/002=
033.html

Hope those messages will provide some help.

As you can see in the messages, I'm using the berlios driver=20
(http://at76c503a.berlios.de/), and then it works just fine, since the=20
sourceforge driver from Atmel doesnt support Intersil anymore (the rs/3=20
uses intersil). Now it works just fine, as you can se here:=20
http://fredrik.agren.se/mrtg/.

By the way, I see you're using Cenara from the emailaddress, where are=20
you connected? Ronneby or Sk=E5ne?

Fredrik =C5gren
Sweden