DVB-T card for mythtv
fabio tirapelle <[email protected]>
| Newsgroups | gmane.linux.drivers.dvb |
|---|---|
| Message-ID | <[email protected]> |
Hi
I have installed mythtv on this configuration:
Asus M3N78-VM GF8200 RGVSM
AMD Ath64 X2LV 3100BOX6000+ 1MB
Haupp. WinTV HVR-1100 -t/a PCI
TechniSat SkyStar 2 DVB-S PCI
nVidia GeForce 8200
Ubuntu 8.10 - Linux htpc 2.6.27-11-generic
Two questions
1) But the Haupp. WinTV will not be found even if I have followed
http://www.linuxtv.org/wiki/index.php/Hauppauge_WinTV-HVR-1110
http://ubuntuforums.org/showthread.php?t=623126&page=2 (#12)
Output of dmesg
[ 13.062214] ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 17
[ 13.062223] b2c2_flexcop_pci 0000:01:06.0: PCI INT A -> Link[LNKA] -> GSI 17 (level, low) -> IRQ 17
[ 13.076654] DVB: registering new adapter (FlexCop Digital TV device)
[ 13.078432] b2c2-flexcop: MAC address = 00:d0:d7:0d:30:88
[ 13.078664] b2c2-flexcop: i2c master_xfer failed
[ 13.078893] b2c2-flexcop: i2c master_xfer failed
[ 13.078895] CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121)
[ 13.078897] CX24123: wrong demod revision: 87
[ 13.101063] saa7130/34: v4l2 driver version 0.2.14 loaded
[ 13.360642] b2c2-flexcop: found 'ST STV0299 DVB-S' .
[ 13.360647] DVB: registering frontend 0 (ST STV0299 DVB-S)...
[ 13.360768] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
[ 13.363507] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 16
[ 13.363517] saa7134 0000:01:07.0: PCI INT A -> Link[LNKB] -> GSI 16 (level, low) -> IRQ 16
[ 13.363523] saa7133[0]: found at 0000:01:07.0, rev: 255, irq: 16, latency: 255, mmio: 0x0
[ 13.363528] saa7133[0]: subsystem: ffff:ffff, board: UNKNOWN/GENERIC [card=0,autodetected]
[ 13.363531] saa7133[0]: can't get MMIO memory @ 0x0
[ 13.363538] saa7134: probe of 0000:01:07.0 failed with error -16
[ 13.393682] saa7134 ALSA driver for DMA sound loaded
[ 13.393685] saa7134 ALSA: no saa7134 cards found
ouput lspci
01:06.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card (rev 02)
01:07.0 Multimedia controller: Philips Semiconductors SAA7131/SAA7133/SAA7135 Video Broadcast Decoder (rev d1)
2) What kind of DVB-T card will you suggest for my configuration instead of "Hauppage WinTv"?
Thanks for help
_______________________________________________
linux-dvb users mailing list
For V4L/DVB development, please use instead [email protected]
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb