Re: wait_for_cmd_done timeout!
Michael Barnes <[email protected]>
| Newsgroups | gmane.linux.drivers.eepro100.devel |
|---|---|
| Message-ID | <[email protected]> |
I just had this problem myself.
Get eepro100-diag.c from http://www.scyld.com/diag. Compile it and run
eepro100-diag -ee
to see if PCI sleep mode is enabled. If it is, then do
eepro100-diag -G 0 -w -w -f
to turn it off. You must then do a cold boot.
Terence Leung wrote:
>
> I have bought a new computer and install Redhat 7.3
> The computer is used as a web server and connected to
> other computer using a switch.
>
> However the computer is unstable. After several
> minutes, it displays like the following:
>
> eepro100 wait_for_cmd_done timeout!
>
> Sometimes, the computer would halt.
>
> It would happen immediately when I use samba to get
> a large file(about 20Mb) from linux to window.
>
> The computer is Intel Pentium4 processor 2.0GHz,
> Intel 10/100M LAN,256MB RDRAM.
>
> Please help. Thank you.
>
>
> =====
> Terence Leung,
> Mobile: 9273 9176
> email: [email protected],
> Homepage:http://tcmleung.uhome.net
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! - Official partner of 2002 FIFA World Cup
> http://fifaworldcup.yahoo.com
> _______________________________________________
> eepro100 mailing list
> [email protected]
> http://www.scyld.com/mailman/listinfo/eepro100
--
Michael Barnes
Core IP Eng - Routing
408-525-2785