Re: how to modify the source?

Donald Becker <[email protected]> Thu, 21 Nov 2002 22:46:00 -0500 (EST)

Newsgroups	gmane.linux.drivers.eepro100.devel
Message-ID	<[email protected]>

On Fri, 22 Nov 2002, gecko wrote:

> when i plug in or pull out the cable in using NIC driver e100, we get some information like "e100: eth1 NIC Link is Up 100 Mbps Full duplex
> "e100: eth1 NIC Link is Down"
>  
> when plugged in/out the cable in eepro100, how can I get information such as link status, as r e100 do.


Use
   mii-diag --status
or
   mii-diag --watch

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993