RE: solved -- Issue with two Intel NICs

Donald Becker <[email protected]> Fri, 6 Jun 2003 11:04:49 -0400 (EDT)
Newsgroups gmane.linux.drivers.eepro100.devel
Message-ID <[email protected]>
On Fri, 6 Jun 2003, Andrea Cogliati wrote:

> Thank you for your support. I upgraded the mobo to the last BIOS
> available from
> Intel and now it works fine. Probably it was some kind of system
> resource
> Conflicts (IRQ or bus master line).

My guess is that it was a bug in the bus master artibration or burst
mode that was solved by changing the bus bridge parameters.

It may have been a firmware bug in the on-board NIC.  That chip is
rumored to have the ability to accept small firmware patches uploaded
just after a hard reset.

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
914 Bay Ridge Road, Suite 220		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993