Re: How to debug my wpa_supplicant connection ?

On 3/1/20 6:30 PM, Jouni Malinen wrote:
>
> I was referring to the priority field within a network block. This is
> the way this is documented in wpa_supplicant.conf:
>
> # priority: priority group (integer)
> # By default, all networks will get same priority group (0). If some of the
> # networks are more desirable, this field can be used to change the order in
> # which wpa_supplicant goes through the networks when selecting a BSS. The
> # priority groups will be iterated in decreasing priority (i.e., the larger the
> # priority value, the sooner the network is matched against the scan results).
> # Within each priority group, networks will be selected based on security
> # policy, signal strength, etc.
>
I had not found that in the "man wpa_supplicant.conf" of debian. I 
should have searched more.

Sorry for the noise.

PC