hp psc 2310 prints slightly too far right

Since there currently isn't a ppd for the 2310 I used the 2300 - everything 
is working really well except for one small annoyance with the paper fitted 
in the correct position the prints are a couple of mm off center. if I move 
the paper it tends to print crooked. Is there any place I can adjust this 
where the print goes to - If so how??? 
 
-- 
Midcoast WebMail (http://mail.midcoast.com.au) 
 


-------------------------------------------------------
This SF.Net email is sponsored by OSTG. Have you noticed the changes on
Linux.com, ITManagersJournal and NewsForge in the past few weeks? Now,
one more big change to announce. We are now OSTG- Open Source Technology
Group. Come see the changes on the new OSTG site. www.ostg.com