monitor-mode is not working

hi,
my ipw2200 worked nice for 12months... in _all_ modes.
but since i reinstalled my complete system the monitor mode is refusing
to work.

the managed mode works nicely but when i place the card via "iwconfig
eth1 mode monitor" into the monitor mode, "ifconfing eth1" shows a
strange hw-address and protocol:

"Protokoll:UNSPEC  Hardware Adresse
00-0E-35-3D-FA-DF-00-00-00-00-00-00-00" (the "true" hw-adress is:
"00:0E:35:3D:FA:DF"

the dmesg-output produced by "modprobe ipw2200" shows a strange
PCI-interrupt (see below). does that mean that the card is broken!?
(remember: in managed-mode it's still working)

i'd be happy about any kind of help

thanks

simon

ps.: i tried all versions of the module from 1.1.0 to 1.1.4, but that
made no difference

###########dmesg-output#############
ieee80211_crypt: registered algorithm 'NULL'
ieee80211: 802.11 data/management/control stack, 1.1.13
ieee80211: Copyright (C) 2004-2005 Intel Corporation
<[email protected]>
ipw2200: Intel(R) PRO/Wireless 2200/2915 Network Driver, 1.1.2dmprq
ipw2200: Copyright(c) 2003-2006 Intel Corporation
ACPI: PCI Interrupt 0000:02:06.0[A] -> Link [LNKG] -> GSI 10 (level,
low) -> IRQ 10
ipw2200: Detected Intel PRO/Wireless 2200BG Network Connection
ipw2200: Detected geography ZZM (11 802.11bg channels, 0 802.11a channels)



-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys -- and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV