Re: 802.11e QoS support

Hi,

When I install the iee802.11 subsystem, i launched make menuconfig to build the kernel. 
Inside there, there's an option "Enable QoS Support" under Networking support > Wireless LAN(non-hamradio) configuration. I enabled it.

Is that the one you mentioned?

If it is, means after I enabled it, the ipw2200 driver will automatically use it right?

If it is not, how do i enable the ieee80211 stack to classify .11e frames?

Thanks.

Regards,

Clement.

----- Original Message ----
From: Zhu Yi <[email protected]>
To: Clement Yew <[email protected]>
Cc: [email protected]
Sent: Thursday, March 13, 2008 11:54:03 AM
Subject: Re: [Ipw2100-devel] 802.11e QoS support


On Wed, 2008-03-12 at 20:31 -0700, Clement Yew wrote:
> How come the ipw2200 source codes has those 802.11e parameters?

The driver and hardware support that but you have to enable the
ieee80211 stack to classify .11e frames.

> Can i use the ipw2200 driver with the newer mac80211?

No.

Thanks,
-yi

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
ipw2100-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/ipw2100-devel