Re: 802.11e QoS support

On Wed, 2008-03-12 at 21:09 -0700, Clement Yew wrote:
> When I install the iee802.11 subsystem, i launched make menuconfig to
> build the kernel. 
> Inside there, there's an option "Enable QoS Support" under Networking
> support > Wireless LAN(non-hamradio) configuration. I enabled it.
> 
> Is that the one you mentioned?
> 
> If it is, means after I enabled it, the ipw2200 driver will
> automatically use it right?
> 
> If it is not, how do i enable the ieee80211 stack to classify .11e
> frames?

The support is not completed. You have no way to fully use it unless you
write the code your own.

-yi


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/