wifi0: ath_chan_set: Unable to reset channel 6 (2437 MHz) flags 0xc0 'Hardware didn't respond as expected' (HAL status 3)

Raghu Ramaraj <[email protected]> Mon, 26 Apr 2010 14:27:32 +0530
Newsgroups gmane.linux.drivers.madwifi.user
Message-ID <DE1563FF5EF45A4794D1220EF0363CB411CE6C71A7@MTW02MSG02.mindtree.com>
Hi,
            Details of my platform

Core                 :DM6467t-Davinci -  ARM9
Linux                : 2.6.32 / 2.6.18
Atheros            : AR5414
Toolchain          : arm_v5t_le-gcc (MontaVista 4.2.0-16.0.32.0801914 2008-08-30)
Madwifi             : madwifi-hal-testing-r4126-20100324
                          madwifi-hal-0.10.5.6-current.tar.gz

Pls find the logs below....

What could be the problem?



[email protected]:~# uname -r
2.6.32-rc2-davinci1
[email protected]:~# lspci
00:05.0 Mass storage controller: Silicon Image, Inc. SiI 3114 [SATALink/SATARaid
] Serial ATA Controller (rev 02)
00:06.0 Ethernet controller: Atheros Communications, Inc. AR5006X 802.11abg NIC
(rev 01)
[email protected]:~# lspci -x
00:05.0 Mass storage controller: Silicon Image, Inc. SiI 3114 [SATALink/SATARaid
] Serial ATA Controller (rev 02)
00: 95 10 14 31 47 01 b0 02 02 00 80 01 08 00 00 00
10: 11 00 00 4a 21 00 00 4a 19 00 00 4a 25 00 00 4a
20: 01 00 00 4a 00 00 09 30 00 00 00 00 95 10 14 31
30: 00 00 00 00 60 00 00 00 00 00 00 00 30 01 00 00

00:06.0 Ethernet controller: Atheros Communications, Inc. AR5006X 802.11abg NIC
(rev 01)
00: 8c 16 1b 00 40 03 90 02 01 00 00 02 08 00 00 00
10: 00 00 08 30 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 01 50 00 00 5f 18 00 16
30: 00 00 00 00 44 00 00 00 00 00 00 00 31 01 0a 1c

[email protected]:~# lspci -v
00:05.0 Mass storage controller: Silicon Image, Inc. SiI 3114 [SATALink/SATARaid
] Serial ATA Controller (rev 02)
        Subsystem: Silicon Image, Inc. SiI 3114 SATALink Controller
        Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 48
        I/O ports at 4a000010 [size=8]
        I/O ports at 4a000020 [size=4]
        I/O ports at 4a000018 [size=8]
        I/O ports at 4a000024 [size=4]
        I/O ports at 4a000000 [size=16]
        Memory at 30090000 (32-bit, non-prefetchable) [size=1K]
        [virtual] Expansion ROM at 30000000 [disabled] [size=512K]
        Capabilities: [60] Power Management version 2

00:06.0 Ethernet controller: Atheros Communications, Inc. AR5006X 802.11abg NIC
(rev 01)
        Subsystem: Wistron NeWeb Corp. DCMA-82 High Power WLAN 802.11a/b/g mini-
PCI Module (Super A/G, eXtended Range, 400mW)
        Flags: fast Back2Back, medium devsel, IRQ 49
        Memory at 30080000 (32-bit, non-prefetchable) [disabled] [size=64K]
        Capabilities: [44] Power Management version 2

[email protected]:~# cd /home/raghu/HAL/wifi/wifi_modules/
[email protected]:/home/raghu/HAL/wifi/wifi_modules# ./install.sh
ath_hal: module license 'Proprietary' taints kernel.
Disabling lock debugging due to kernel taint
AR5210, AR5211, AR5212, AR5416, RF5111, RF5112, RF2413, RF5413, RF2133, RF2425,
RF2417, REGOPS_FUNC)
wlan: mac acl policy registered
in function __pci_register_driver
PCI: enabling device 0000:00:06.0 (0340 -> 0342)
MadWifi: ath_attach: Switching rfkill capability off.
wifi0: Atheros AR5414 chip found (MAC 10.5, PHY SChip 6.1, Radio 6.3)
ath_pci: wifi0: Atheros 5413: mem=0x30080000, irq=49
in function __pci_register_driver after driver reg
in function __pci_register_driver after pci_create_newid_file
in function __pci_register_driver after pci_create_removeid_file
[email protected]:/home/raghu/HAL/wifi/wifi_modules#
[email protected]:/home/raghu/HAL/wifi/wifi_modules# iwconfig
iwconfig: Symbol `iw_operation_mode' has different size in shared objectnet eth0
: DaVinci EMAC: ioctl not supported
, consider re-linking
lo        no wireless extensions.

eth0      no wireless extensions.

wifi0     no wireless extensions.

wlan0     IEEE 802.11b  ESSID:""  Nickname:""
          Mode:Managed  Channel:0  Access Point: Not-Associated
          Bit Rate:0 kb/s   Tx-Power:0 dBm   Sensitivity=1/1
          Retry:off   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=0/70  Signal level=0 dBm  Noise level=0 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

[email protected]:/home/raghu/HAL/wifi/wifi_modules# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:0E:99:02:B5:67
          inet addr:172.22.66.12  Bcast:172.22.79.255  Mask:255.255.240.0
          inet6 addr: fe80::20e:99ff:fe02:b567/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:15390 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6572 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:10004560 (9.5 MiB)  TX bytes:1090732 (1.0 MiB)
          Interrupt:24

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:8 errors:0 dropped:0 overruns:0 frame:0
          TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:560 (560.0 b)  TX bytes:560 (560.0 b)

[email protected]:/home/raghu/HAL/wifi/wifi_modules# ifconfig wlan0 up
[email protected]:/home/raghu/HAL/wifi/wifi_modules# cd ..
[email protected]:/home/raghu/HAL/wifi# cd wifi_apps/
[email protected]:/home/raghu/HAL/wifi/wifi_apps# ./wlanconfig wlan0 list scann
[email protected]:/home/raghu/HAL/wifi/wifi_apps# wifi0: ath_chan_set: Unable to
 reset channel 6 (2437 MHz) flags 0xc0 'Hardware didn't respond as expected' (HA
L status 3)
./wlanconfig wlan0 list scannwifi0: ath_chan_set: Unable to reset channel 7 (244
2 MHz) flags 0xc0 'Hardware didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 56 (5280 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 64 (5320 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 40 (5200 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 48 (5240 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 3 (2422 MHz) flags 0xc0 'Hardware d
idn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 5 (2432 MHz) flags 0xc0 'Hardware d
idn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 9 (2452 MHz) flags 0xc0 'Hardware d
idn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 149 (5745 MHz) flags 0x140 'Hardwar
e didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 157 (5785 MHz) flags 0x140 'Hardwar
e didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 165 (5825 MHz) flags 0x140 'Hardwar
e didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 50 (5250 MHz) flags 0x150 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 152 (5760 MHz) flags 0x150 'Hardwar
e didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 40 (5200 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 56 (5280 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 161 (5805 MHz) flags 0x140 'Hardwar
e didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 1 (2412 MHz) flags 0xc0 'Hardware d
idn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 7 (2442 MHz) flags 0xc0 'Hardware d
idn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 56 (5280 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)
wifi0: ath_chan_set: Unable to reset channel 64 (5320 MHz) flags 0x140 'Hardware
 didn't respond as expected' (HAL status 3)






Thanks & Regards,
Raghu Ramaraj


________________________________
http://www.mindtree.com/email/disclaimer.html

------------------------------------------------------------------------------

_______________________________________________
Madwifi-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/madwifi-users