Re: SMC2802W reset timeout
Bob Farmer <[email protected]>
| Newsgroups | gmane.linux.drivers.prism54.user |
|---|---|
| Message-ID | <[email protected]> |
Erik Gustavsson wrote: > On Sat, 2004-04-03 at 11:18, Rainer Keuchel wrote: > >>>I'm trying to get my shiny new SMC2802 card running, but it >>>doesn't seem to start up correctly. It seems to load the firmware OK then >>>fail while resetting. >> >>The chip is not supported by the prism54 driver. >>Try the latest ndiswrapper.. >> > > > Well, I'm getting the same error but my card is SMC2802W (not V2). > Is there any work being done to solve this problem? I'd be glad to help > if I can... > > If it can't be solved, do any other 11G chipsets have proper linux > drivers with master mode support? > > /cyr > > _______________________________________________ > Prism54-users mailing list > [email protected] > http://prism54.org/mailman/listinfo/prism54-users I had this problem when the firmware version I was using was old. Have you tried all the firmware versions from prism54.org? Bob