Re: SMC2802W reset timeout

On Sun, 2004-04-04 at 01:49, Bob Farmer wrote:
> Erik Gustavsson wrote:
> > On Sat, 2004-04-03 at 11:18, Rainer Keuchel wrote:
> > 
> >>>I'm trying to get my shiny new SMC2802 card running, but it
> >>>doesn't seem to start up correctly. It seems to load the firmware OK then
> >>>fail while resetting.
> >>
> >>The chip is not supported by the prism54 driver.
> >>Try the latest ndiswrapper..
> >>
> > 
> > 
> > Well, I'm getting the same error but my card is SMC2802W (not V2).
> > Is there any work being done to solve this problem? I'd be glad to help
> > if I can...  
> > 
> > If it can't be solved, do any other 11G chipsets have proper linux
> > drivers with master mode support?
> > 
> > /cyr
> > 
> > _______________________________________________
> > Prism54-users mailing list
> > [email protected]
> > http://prism54.org/mailman/listinfo/prism54-users
> 
> I had this problem when the firmware version I was using was old.  Have 
> you tried all the firmware versions from prism54.org?
> 

I'm afraid so, every version om prism54.org and also the .arm file that
came with the card...   

Also the interrupt count for IRQ11 (the prism54 card) in
/proc/interrupts stays at zero.

/cyr