EAP-TLS now possible as WPA support integrated?

Hi,

I want to use my prism54 card as access point with EAP-TLS. I know how to do 
it with hostap. But I didn't found any info how to do it with the prism54 
card.
 
Its basically WPA (which is now supported I read), but the authentication is 
handled via hostapd and than freeradius. So the encryption is WPA but not the 
authentication. Authentication works via IEEE 802.1x and EAP and EAP-TLS is 
the authentication method I would like to use. other methods would be EAP-MD5 
or EAP-SIM. 
 
 On the WPA site is just an dynamic WEP-key set by EAP-TLS. 
 
 so in short: I'm missing something like hostapd. Or can I used that also with 
prism54 as I read that most WPA code came from hostap.

-- 
Regards,
Robert
----------
Robert Penz
robert dot penz at outertech dot com

_______________________________________________
Prism54-users mailing list
[email protected]
http://prism54.org/mailman/listinfo/prism54-users

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQBBUYlY8tTsQqJDUBMRAoMhAJ9ETG+wxBJMbuldao9QegFWBgNV+ACfXEmf
y94ZS750MufijgGiZ9jgz/c=
=ilq5
-----END PGP SIGNATURE-----