Re: do I need to download a driver for 2.6.11 ?
"Eero Volotinen" <[email protected]> Tue, 24 May 2005 10:47:24 +0300 (EEST)
| Newsgroups | gmane.linux.drivers.prism54.user |
|---|---|
| Message-ID | <[email protected]> |
> After removing it and putting the driver in the right place, I get in > dmesg: > eth2: resetting device... > eth2: uploading firmware... > eth2: firmware version: 1.0.4.3 > eth2: firmware upload complete > eth2: no 'reset complete' IRQ seen - retrying > eth2: no 'reset complete' IRQ seen - retrying > eth2: interface reset failure > prism54: Your card/socket may be faulty, or IRQ line too busy :( Is your card supported? Version 1? If it is, then try latest cvs/svn sour= ces. If I remember right, there is fix for that problem. If you card is not supported, then no can do. -- Eero