Re: do I need to download a driver for 2.6.11 ?
Ulrich Lauther <[email protected]> Tue, 24 May 2005 12:15:07 +0200 (MEST)
| Newsgroups | gmane.linux.drivers.prism54.user |
|---|---|
| Message-ID | <[email protected]> |
> > > > After removing it and putting the driver in the right place, I get in > > dmesg: > > eth2: resetting device... > > eth2: uploading firmware... > > eth2: firmware version: 1.0.4.3 > > eth2: firmware upload complete > > eth2: no 'reset complete' IRQ seen - retrying > > eth2: no 'reset complete' IRQ seen - retrying > > eth2: interface reset failure > > prism54: Your card/socket may be faulty, or IRQ line too busy :( > > Is your card supported? Version 1? If it is, then try latest cvs/svn sources. > what is svn ? > If I remember right, there is fix for that problem. > How can I find out whether it is Version 1 or 2? The part number is 99-01208084-338 and SubAssembly Part number 91-01208084-338. lspci -n : 07:00.0 Class 0280: 1260:3890 (rev 01 lspci : 07:00.0 Network controller: Harris Semiconductor: Unknown device 3890 (rev 01) > If you card is not supported, then no can do. > -ulrich ---------------------------------------------------------------------------- Ulrich Lauther ph: +49 89 636 48834 fx: ... 636 42284 Siemens CT SE 6 Internet: [email protected]