8139too and rtl8139

Karl Bellve <[email protected]> Tue, 22 Jun 2004 12:30:12 -0400

Newsgroups	gmane.linux.drivers.realtek.devel
Message-ID	<[email protected]>



 From the 8139too driver I get the following errors reported during 
large transfers..
eth0: Too much work at interrupt, IntrStatus=0x0040.
eth0: Too much work at interrupt, IntrStatus=0x0041.

But, from a recent rtl8139 driver, the network just drops out during 
large transfers.
"rtl8139.c:v1.24 11/13/2003 Donald Becker, [email protected].

I would like to track down this problem. It only started really after I 
upraded from RH8.0 to RH9.

I seem to remember loosing the network with some early drivers, like 
pre1.06 but that was a long time ago.

-- 
Cheers,



Karl Bellve, Ph.D.                   ICQ # 13956200
Biomedical Imaging Group             TLCA# 7938 		
University of Massachusetts
Email: [email protected]
Phone: (508) 856-6514
Fax:   (508) 856-1840
PGP Public key: finger [email protected]
http://invitro.umassmed.edu/~kdb/grok_is.html