tulip.o: invalid parameter parm_debug
"Kai Hackemesser" <[email protected]> Fri, 17 May 2002 01:22:23 +0200
| Newsgroups | gmane.linux.drivers.tulip.bugs |
|---|---|
| Message-ID | <000201c1fd30$8f968b30$150ca8c0@sirius> |
Hello, I hope I=B4m on the correct mailing list now. I own a notebo... Command? which has a Linksys NC100 network chipset implemented. As ... Command? I have to use the tulip module for it. I now have compiled kernel 2.4.18 on that notebook, tulip as module.=20 If I do "modprobe tulip" I get following error (in short): invalid parameter parm_debug insmod failed. I've even checked the tulip sourcecode, but didn=B4t found a solution=20 for it. Maybe someone here? ciao! Kai _______________________________________________ tulip-bug mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip-bug