tulip.o: invalid parameter parm_debug - corrected
"Kai Hackemesser" <[email protected]> Fri, 17 May 2002 07:33:41 +0200
| Newsgroups | gmane.linux.drivers.tulip.bugs |
|---|---|
| Message-ID | <000501c1fd64$6acc37d0$150ca8c0@sirius> |
Hello, I hope I=B4m on the correct mailing list now. I own a notebook computer which has a Linksys NC100 network chipset implemented. As far as I found I have to use the tulip module for it. I now have compiled kernel 2.4.18 on that notebook, tulip as module. If I do "modprobe tulip" I get following error (in short): invalid parameter parm_debug insmod failed. I've even checked the tulip sourcecode, but didn=B4t found a solution for it. Maybe someone here? ciao! Kai _______________________________________________ tulip-bug mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip-bug