Re: tulip.o: invalid parameter parm_debug - corrected

On Fri, 17 May 2002, Kai Hackemesser wrote:

> I hope I=B4m on the correct mailing list now. I own a notebook computer
> which has a Linksys NC100 network chipset implemented. As far as I foun=
d
> I have to use the tulip module for it. I now have compiled kernel 2.4.1=
8
> on that notebook, tulip as module. If I do "modprobe tulip" I get
> following error (in short):
>
> invalid parameter parm_debug
> insmod failed.

You are passing a debug parameter from somewhere in your setup.

Is the NIC a CardBus card, or a PCI implementation (mini-PCI or
built-in).

If CardBus, the module option is probably set in /etc/pcmcia/config or
/etc/pcmcia/config.opts.
If PCI, the module option is probably set /etc/modules.conf.

--=20
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Second Generation Beowulf Clusters
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip-bug mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip-bug