Re: tulip not correctly identifying LNE100TX

On Tue, 9 Jul 2002, Donald Becker wrote:
> > Is there any way to tell the driver, that it is indeed an LNE100TX and not an
> > ADMtek Centaur-P?
> Uhhmmm, it's a ADMtek Centaur-P chip.  There is likely a PCI subsystem
> ID programmed into the EEPROM that identifies the board as having a
> Linksys label, but that has no impact on operation.

00:04:5A is listed to linksys, it should be possible to identify as 
LNE100TX if required. IIRC 00:04:5A is only on newer LNE100TX's, older 
model LNE100TX's with Centaur-P use 00:20:78.

It may be possible to use the MAC to specifically identify other cards 
that have unique tweaking requirements... may not be possible to uniquely 
identify every single card in existence, but should be possible to 
identify at least some.

-Dan
-- 
[-] Omae no subete no kichi wa ore no mono da. [-]

_______________________________________________
tulip-bug mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip-bug