Re: tulip not correctly identifying LNE100TX
Donald Becker <[email protected]> Tue, 9 Jul 2002 15:00:47 -0400 (EDT)
| Newsgroups | gmane.linux.drivers.tulip.bugs |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 9 Jul 2002, Dan Hollis wrote: > On Tue, 9 Jul 2002, Donald Becker wrote: > > > Is there any way to tell the driver, that it is indeed an LNE100TX and not an > > > ADMtek Centaur-P? > > Uhhmmm, it's a ADMtek Centaur-P chip. There is likely a PCI subsystem > > ID programmed into the EEPROM that identifies the board as having a > > Linksys label, but that has no impact on operation. > > 00:04:5A is listed to linksys, it should be possible to identify as > LNE100TX if required. Using the station address to identify boards is not a good idea. Linksys has sold Ethernet adapters based on many different chips. The previous LNE100TX v2 and v3 boards were based on the PNIC and PNIC-2. The only place the driver uses the station address is very old 21140 boards without transceiver/media description tables. It was very painful to develop those tables, and the approach only works because vendors stopped making new boards without media tables. > IIRC 00:04:5A is only on newer LNE100TX's, older > model LNE100TX's with Centaur-P use 00:20:78. ... making my point about station addresses not identifying boards. > It may be possible to use the MAC to specifically identify other cards > that have unique tweaking requirements. The ADMtek Centaur is an all-in-one chip. There is no way for a board designer to screw it up, so there no reason to identify the specific board. If the board subsystem ID is unique, it's easy enough to add a new table entry to match only that ID. The only reason to do this is for a friendly detection message, not to fix a bug. Thus I won't add a table entry unless I'm very certain of the information. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Second Generation Beowulf Clusters Annapolis MD 21403 410-990-9993 _______________________________________________ tulip-bug mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip-bug