Re: tulip not correctly identifying LNE100TX

On Tue, 9 Jul 2002, Donald Becker wrote:
> > IIRC 00:04:5A is only on newer LNE100TX's, older 
> > model LNE100TX's with Centaur-P use 00:20:78.
> ... making my point about station addresses not identifying boards.

It did change exactly at rev4 to rev4.1, IIRC. As to whether its useful 
information is another story altogether.

> > It may be possible to use the MAC to specifically identify other cards 
> > that have unique tweaking requirements.
> The ADMtek Centaur is an all-in-one chip.  There is no way for a board
> designer to screw it up, so there no reason to identify the specific
> board.

This may be true for Centaur, but perhaps could be applied to other tulip 
clones which require special tweaks or manual workarounds.

> If the board subsystem ID is unique, it's easy enough to add a new table
> entry to match only that ID.  The only reason to do this is for a
> friendly detection message, not to fix a bug.  Thus I won't add a table
> entry unless I'm very certain of the information.

Vendors populating PCI subsystem IDs of any hardware seems very rare, even 
though it would be immensely helpful :-/

But arent there some tulip clones which require special tweaks or 
workarounds, especially some multiport cards? If it were possible to 
positively identify them through MAC/subsystem ID or a combination, it 
might be useful.

-Dan
-- 
[-] Omae no subete no kichi wa ore no mono da. [-]

_______________________________________________
tulip-bug mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip-bug